Error Code 0x8024402f Appears When You Update Windows Update

Error Code 0x8024402f is common for all the Windows Operating systems when you try to install the updates. It usually appears when Windows 10 or Windows 7 update system is broken or there are network related glitches. The 0x8024402F Update error, commonly is caused due to poor Internet connection or if the Windows Update store folder becomes corrupted.

Reasons for this Error Code 0x8024402f :

Usual causes for this error code 0x8024402f are communication failure over the Internet with Microsoft update servers.

Troubleshooting Steps for Error Code 0x8024402f :

Disable the proxy Internet connection and try again to install the update.

The Procedure to Disable the Proxy Connection is as Follows:

1. Firstly, Open Internet Explorer and click on Tools->Internet Options.
2. Secondly, Go to Connections and LAN Settings.
3. Finally, Check to make sure the Proxy server is disabled.

The second case would be with your Antivirus. If you cannot find the procedure to stop it, you can ask our techs on chat support to guide you.

Repair the Windows Update Services to Fix Error Code 0x8024402f :

Try the Below steps to Repair Windows Services:

Repairing Windows update services is not possible like you repair any windows apps from the add/remove programs. There is a procedure that you need to follow through command lines.

This requires the user to have administrator rights on his computer. As per the Microsoft set of rules defined on various Knowledge base articles, the steps are simplified as mentioned here to reset your windows update services.

NOTE: Following these steps carefully will not make any changes to your personal data or programs. It will only reset the Windows update services.

1. Firstly, Open a command prompt as administrator by right-clicking on it.
2. Secondly, go to c:\windows\
3. Thirdly, rename software distribution folder to old
4. After this, some cases it may not happen until you stop the windows update services
5. To stop that, you can run a command-line net stop wuauserv and hit enter
   
   
6. Next, followed by you can try to rename this folder software distribution to old
7. Then you can restart the windows update service
8. After this, Use this command “net start wuauserv” and hit enter
   
   
9. Finally, Check for updates now.

For any additional support in fixing windows update related errors like Error code 0x8024402f or any, you can reach us on chat here to get instant Help and Support.